#ADD COMMENTS TO GX WORKS 2 SOFTWARE#
#ADD COMMENTS TO GX WORKS 2 SERIES#

To write the vision system's parameters, from the Method selection drop-down list, select Parameter write.

The vision system's parameter values will be displayed in the Read Value column.

Confirm that the checkboxes for the parameter to be read are checked.

To read the vision system's parameters, from the Method selection drop-down list, select Parameter read.

The Parameter Processing of Ethernet Device window will be displayed. Select Online -> Parameter Processing of Ethernet Device. Right-click the target In-Sight vision system on the device map area. Note: For detailed SLMPВ Scanner parameter information, refer to the SLMPВ Scanner Parameters section. Reading and Writing SLMPВ Scanner Parameters

The communication settings will be now reflected to the selected vision system. Select Online -> Communication Setting Reflection of Ethernet Device.Right-click the target vision system on the device map area. Select the target In-Sight vision system and configure the communication settings.(To display this window, refer to the Discovering In-Sight vision systems on GXВ Works section). From GX Works, open the Ethernet Configuration window.Execute this feature after adding/deleting or changing the settings of vision systems. The communication settings, such as the IPВ address, can be reflected to the In-Sight vision system. Reflect the Communication Settings to In-Sight Vision Systems For troubleshooting, refer to Mitsubishi's iQВ Sensor SolutionВ Reference Manual.

Double-click the error on the Output window and correct the error at the error jump destination. Error information is displayed on the Output window when there is an error in the system configuration after executing the automatic detection of connected devices.If a vision system is iQSS-compatible but no profile was previously added to GX Works, 'Module With No Profile Found' will be displayed. If the Detect Now button is pressed, and a vision system in the network is not iQSS-compatible, the vision system will not appear in the Ethernet configuration window.Up to 16 In-Sight vision system may be displayed (in ascending order of their IPВ addresses) on the Ethernet Configuration window after executing the automatic detection of connected devices.With the iQ Sensor Solution, GXВ Works is able to discover vision systems on the network, read/write the vision system's SLMPВ Scanner parameter settings and monitor the status of a vision system. For more information, see Configuring In-Sight Vision Systems for SLMP Communications.

#ADD COMMENTS TO GX WORKS 2 SOFTWARE#

Mitsubishi iQВ Sensor Solution is a factory protocol that enables the GX Works software to control In-Sight vision systems over the SLMP Scanner protocol.

For more information on Mitsubishi iQ Sensor Solution, refer to Mitsubishi's iQВ Sensor SolutionВ Reference Manual.

It is recommended that you keep PLC projects within the same language of GX Works. the PLC project is created in the Japanese version of GX Works and then uploaded to an English version of GX Works. This issue also occurs if the process is reversed, i.e.

#ADD COMMENTS TO GX WORKS 2 SERIES#

If a PLC project created in the English version of GXВ Works is downloaded to the PLC, and then uploaded to a Japanese version of GX Works, In-Sight 5000 and In-Sight 70xx - 74xx series vision systems will be missing their icons and descriptive information.

IQ Sensor Solution is only available on In-Sight vision systems using In-Sight firmware 4.x.x, or 5.7.4 or later.

Add comments to gx works 2